2014/11/06

DISCLAIMER: These notes are from the defunct k8 project which precedes SquirrelJME. The notes for SquirrelJME start on 2016/02/26! The k8 project was effectively a Java SE 8 operating system and as such all of the notes are in the context of that scope. That project is no longer my goal as SquirrelJME is the spiritual successor to it.

03:29

Actually instead of rewriting all of this, I am just going to fix what I do not like about my existing code.

04:08

Made the attributes for classes and methods just be an individual list, that works better.

05:23

The one thing I do not like is the ConstantPool class, the entries specifically. I made the pool better by allowing it to be grown and having one permanently attached to a class (no new junk). The bad remaining part is the entries, I need a way to dynamically create the entry classes to my specifications. There are annotation processors but I have never used that stuff yet, and I am not too sure if it suits my needs.

06:49

Figured out a benefit of Java, in the case of NUMA systems and clusters where there are potentially many different systems, they can all act as CPUs to compute the same stuff even if they vary in architecture. Provided that all of the implementations are correct and act the same on each architecture there would not be any problems much.

13:35

Need to figure out some things, I figure the best thing to do would be to have classes in individual files and translate them on the go. The kernel can be kept minimal in binary size by just loading class stuff as needed. Drivers for things would just be another set of class files. Although the grouping becomes vague, what is the kernel and what is loaded from the disk? In essence everything can be on the disk, and the kernel could be a level one hypervisor setup by the bootloader which loads the initial classes. There will need to be at least one hypervisor which manages the system threads and such, but where does that start and where does it end? If I have the kernel just be a giant glob of precompiled classes, I could end up having the entire classpath be in the binary because of the way dependencies work. So I will need some kind of vmstrap system. Either something in assembly, or C, that sets up the kernel state and loads it. Could probably do it Java however. So I will need a bare minimum setup. Then that bare minimum can load classes from the disk and compile them as needed (say if one decided to delete the cache for the kernel which would force it to recompile). Anything that exists as part of the boot strap would have to be very minimal. So that would include the bootloader and the class recompiler. This means that I will have to modify some of the class loading stuff to remove some dependencies that it requires (such as PrintWriter for my current debugging).